Honeywell MAGICSTAT 3355 Bedienungsanleitung PDF herunterladen (Seite 18)

69-1012

Step 5: Adjust Fan Operation Switch, as Required

■■ The thermostat fan operation switch,

labeled FUEL SWITCH (see illustration on

page 20) is factory-set in the F position. This

is the correct setting for most systems. If

your system is an electric heat system, set

the switch to E. The E setting allows the fan

to turn on immediately with the heating or

cooling in a system where the G terminal is

connected.

Step 6: Adjust System On-Time,

F/C

, as Required

■■ The system on-time is factory-set for a warm

air, gas or oil heating system. If you are

installing it on another type of system, adjust

the on-time accordingly by setting screws A

and B on the back of the thermostat. Use the

heating system table shown in the illustration

(page 20) as a guide. Optimize the system

on-time according to the type of system to

minimize room temperature swings. Setting

the screw

out one turn

means turning the

screw approximately 360° counterclockwise,

or about one complete turn.

In the unlikely event that you want a longer

system on-time, readjust screws A and/or B

as follows:

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 39 40

Keine Kommentare

Honeywell MAGICSTAT 3355 Bedienungsanleitung Seite 18