Honeywell Dolphin 7600 Betriebsanweisung PDF herunterladen (Seite 43)

3 - 25

Resetting the Terminal

There are two ways to reset the Dolphin terminal: a soft reset and a hard reset.

Soft Reset (Warm Boot)

A soft reset re-boots the terminal without losing RAM data. You would perform a soft reset 1) after

installing software applications that require a reboot, 2) after making changes to certain system settings,

or 3) when the terminal fails to respond.

1. Press and hold Red + ESC for approximately 5 seconds. The screen turns white and the

decode and scan LEDs flash for approximately three seconds.

2. When the reset is complete, the Today Screen (see page 2-2) appears.

Hard Reset (Cold Boot)

A hard reset erases all of the data and applications stored in RAM memory and launches AutoInstall, which

re-initializes the terminal.

Hard resets automatically launch a soft reset as part of the boot process.

1. Press and hold Red + TAB for approximately 5 seconds. The screen turns white and the

decode and scan LEDs light for approximately three seconds.

2. The terminal re-initializes, which re-installs all programs stored in the \IPSM\Autoinstall folder.

Note: Set the time and date after each hard reset to ensure that the system clock is accurate. Tap the date on the

Today Screen (see page 2-2) to open the Clock setting and set the time and date.

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 143 144

Keine Kommentare

Honeywell Dolphin 7600 Betriebsanweisung Seite 43