Honeywell CT50 Bedienungsanleitung PDF herunterladen (Seite 4)

CT50 Series • Owner's Manual

69-2040EFS—01 4

M23794

1. Aligntheslotsonthecoverwithtabson

the sides of the base, then push gently

until the cover snaps into place.

2. Restore power at the heating/cooling sys-

tem, or at the fuse/circuit-breaker panel.

Movetheswitchtothepropersettingforyour

system:

F:Forgas or oil heating systems, leave the

fan operation switch in this factory-set position

(for systems that control the fan in a call for

heat).

E: Change the switch to this setting for heat

pump or electric heat systems. (This setting

is for systems that allow the thermostat to

control the fan in a call for heat, if a fan wire is

connected to the G terminal.)

Set fan operation switch (CT51/CT55)

Finish installation

M23796

Tab

Movetheadjustmentarrowtothe

proper setting for your system

(see table below).

Your system Setting

Steam 1.2

Hotwaterheat 0.8

Warmair(highefciency) 0.8

Warmair(standard) 0.4

Electricheat 0.3

M23795

Set heat anticipator (select models)

1 2 3 4 5 6 7 8 9 ... 15 16

Keine Kommentare

Honeywell CT50 Bedienungsanleitung Seite 4